Vertrod V14D/SL Drop Sealer
Product Info
The Vertrod D/SL-AE is a heavy-duty drop sealer with seven inch jaw opening to allow for pass-through product loading.This model is equipped with an Air Expeller assembly for compressing flexible packages, eliminating excess air, and reducing overall package volume. The direct drive jaw motion provides high sealing pressure and is capable of making airtight/watertight seals with temperatures ranging from 200?F to 650?F. The D/SL employs PAC’s state of the art solid-state control circuitry along with an improved safety system.
Vertrod Drop Sealers are built for the most demanding requirements to decrease overall packaging time. This model is often used in conjunction with a bag opener to speed up the bag loading process. The filled bag is fed through the sealing jaws to an angled out-feed table where the bottom of the bag is supported. A photocell detects when the product is in position, activating the air expeller assembly to compress and force air out of the package. An adjustable timer allows for varying the jaw closure independent of the air expeller to insure maximum compression and evacuation of air prior to initiating the sealing cycle. Once the sealing cycle has ended, the support fingers retract, allowing the sealed bag to slide from the out-feed table. Simultaneously, the jaws open allowing the next filled bag to be fed. The D/SL is adjustable for intermittent use by footswitch or palm button as well.
The Vertrod D/SL Drop Sealer sealer is available in four seal lengths ranging from 14” to 30” with a variety of options for flat seals, trim seals, or a combination of both. Standard model features are listed below with a selection of available options. Contact a Vertrod representative for more information and details on custom applications.
- Available in four seal lengths ranging from 14” to 30” with a variety of options for flat seals, trim seals, or a combination of both.
- Single side heater bar with opposing pressure bar (bottom jaw heated).
- Thermal impulse time control system.
- Independent seal and cool timers from 0 to 3.75 seconds (.25 second increments).
- Direct drive jaw motion for increased sealing pressure.
- Lower cylinder structure to allow for 7” jaw opening product clearance.
- Air expeller assembly for compression of product and evacuation of air.
- Adjustable bag support/release finers to accommodate various package lengths.
- Out-feed table is height and angle adjustable.
- Heavy-duty welded steel frame with hammer tone gray powder coat finish.
- Pneumatic low-pressure jaw close safety system with release if obstruction detected.
- Photo eye cycle activation in automatic mode. Food switch activiation in manual mode.
- Compressed air operated: 60PSIG
- Made in USA
- 3 year limited warranty
Item Specifications
-
115VAC, single phase standard
-
14
-
1/4